Some codec47 frames come with an interpolation table:
Combining 2 adjacent pixels into a 16bit value, this value can
then be used as index into the interpolation table to get a new
pixel value. This is used for subcodec 1, which encodes a key-
frame at half width and height, and makes these frame less blocky
appearing.
Signed-off-by: Manuel Lauss <manuel.lauss@gmail.com>
Signed-off-by: Anton Khirnov <anton@khirnov.net>
When RPU is removed EL should also be removed. This only applies to
HEVC as AV1 based Profile 10 does not support EL at all.
Signed-off-by: Gnattu OC <gnattuoc@me.com>
Signed-off-by: Anton Khirnov <anton@khirnov.net>
According to the GL_EXT_buffer_reference spec alignment
"must be a power of two and be greater than or equal to the largest scalar/component type in the block."
This means by using u32vec2 we can drop the requirement alignment from 8 bytes to 4 bytes
and save a pack64 call in reverse8 (though I assume in most ISAs that compiles to nothing)
Allows the vc2 vulkan encoder to function without setting PB_UNALIGNED
If caller wrote a divisible by eight number of bits it would write an extra byte.
Also increment by to_write instead of BUF_BYTES which overly pads the bitstream.
The function is quite important to ensure that the output
is always going to be sufficient, and it can change version to
version, so exposing it makes sense.
This allows the encoder to fully saturate all queues the GPU
has, giving a good 10% in certain cases and resolutions.
This also improves error resilience if an allocation fails,
and properly cleans up after itself if it does.
The current parser does things which a parser should not, like skipping parts
of the packet header, but it does not actually able to packetize a raw DNXUC
bitstream.
Rework the parser logic to work similar to other parsers and be able to
correctly packetize raw DNXUC bitstreams.
Bump minor version because the DNXUC codec packet format changes with this.
Normally this would be a breaking change, but in this particular case it should
not cause any issues in practice because the DNXUC codec is relatively new and
we never added a decoder for it.
Signed-off-by: Marton Balint <cus@passwd.hu>
This is an experimental and research codec of which ffmpeg is the only
encoder and decoder, development has stalled since 2013 and these files
don't exist in the wild.
Deprecate the encoders to be removed next major bump, decoders to be
removed one bump afterwards. We also disable the the encoders by default
in configure, the decoders should be disabled by default next bump.
Signed-off-by: J. Dekker <jdek@itanimul.li>
Signed-off-by: Vittorio Giovara <vittorio.giovara@gmail.com>
Ensure downmixed is only set once during init, as it used to be.
Fixes a regression since acbb2777e2.
Fixes ticket #11321
Signed-off-by: James Almer <jamrial@gmail.com>
xHE-AAC is a profile where some frames depend on other key frames, named IPF.
By setting the codec as Intra Only, all frames output by decoders and all
packets output by encoders/demuxers will be unconditionally flaged as
keyframes, which is incorrect.
Should fix ticket #11272.
Signed-off-by: James Almer <jamrial@gmail.com>
For example, with
./ffmpeg -operating_rate 400 -hwaccel mediacodec -i test.mp4 -an \
-c:v h264_mediacodec -operating_rate 400 -b:v 5M -f null -
The transcoding speed is 254 FPS.
Without -operating_rate on dec/enc, the speed is 148 FPS.
With -operating_rate on decoder only, the speed is 239 FPS.
Signed-off-by: Zhao Zhili <zhilizhao@tencent.com>
The codec wants to know whether the usecase is realtime playback
or full-speed transcoding, or playback at a higher speed. The codec
runs faster when operating_rate higher than framerate.
Signed-off-by: Zhao Zhili <zhilizhao@tencent.com>
Unlike the software FFv1 encoder, none of our buffers are allocated by
FFmpeg, which supports at most 4GiB large allocations.
For really large sizes, the maximum size of the buffer can exceed 4GiB,
which the software encoder optimistically tries to allocate as 4GiB
in the hopes that the encoder will compress to under that amount.
We can just let Vulkan allocate us a larger buffer, and switch to
64-bit offsets.
As of 459a1512f1,
the code is unrolled to process two rows per iteration.
The output cursor thus needs to be incremented by twice the
stride, which is taken care of with SH1ADD. However the original
ADD from the original implemetation was incorrectly left over.
Manuel LaussandAnton Khirnov
Nicolas GaullierandAnton Khirnov
gnattu via ffmpeg-develandAnton Khirnov
IndecisiveTurtleandLynne
Scott TheisenandMarth64
Sean McGovernandZhao Zhili
Marton Balint
J. DekkerandVittorio Giovara
James Almer
Rémi Denis-Courmont
Michael Niedermayer
Peter Ross
Eugene ZemtsovandMarth64